If you work in a hospital with an intensive care unit, you will probably be familiar with the exercise of transferring drips and infusion pumps from the drip stand attached to the patient's bed to a mobile drip stand. This process can add 10 minutes to the beginning of a procedure and 10 minutes to the end of a procedure. The Fronsko Dripstand Base (FDB) was designed to eliminate the need for transferring drips and pumps to a mobile drip stand.

The concept behind the FDB was to have a very heavy mobile base that would accommodate the drip stand attached to the bed. The dip stand pole is simply lifted off the bed and placed into the FDB.

The FDB is made of powdercoated mild steel. The legs are solid 20mm flat bar. The unusual configuration at the top is to accommodate a particular type of drip stand that was in use at the time. The wheels are lightweight casters.

When the patient arrives for a procedure in the X-ray department, the drip stand attached to the patient's bed is lifted off and placed in the FDB as shown below.

The FDB has a very low centre of gravity and will remain relatively stable even under heavy loads. After many years of use it has never fallen over (that's not to say that it couldn't- take care).

The FDB is basically a time saving device which makes an imaging examination on a patient who has been transfered from the Intensive Care Unit a much quicker procedure.

It is useful to have two on hand for patients with two bedmounted drip poles

• A heavily laden bed-mounted drip stand can require two people to safely lift it into the FDB.

• If the ICU changes its beds, the new beds may require the FDB to be altered.

• Some ICU beds do not have removable drip stands

• Definitely cannot be used in MRI (although I suspect a non-ferrous version could be made with aluminium and lead)

• Lowering a bed or imaging equiment onto the FDB is hazardous

• A newer model was made that accommodated different sizes/diameters of drip poles.

• A threaded locking screw was incorporated which could be used to hand tightened the transfered drip pole into the FDB

• The casters do not wheel as well as they should. A more expensive caster will be used on future models.

• The goose-neck in the legs of the base may be unnecessary. The FDB will be much easier to manufacture if the legs are straight.

• Do not try and make one with less than 5 legs- it will be too unstable

The Fronsko Drip Stand Base has proven itself over many years to be a potent time-saver. It is relatively easy to manufacture and is durable